9-18
User Authentication and Accounting (User Login, Job Accounting) > Setting User Login Administration
Group Auth. (Group Authorization Settings)
Set restrictions of the machine usage by each individual group registered in the authentication server.
1
Display the screen.
1 Press the [System Menu/Counter] key.
2 Press the [ā²] or [ā¼] key to select [User/Job Account], and press the [OK] key.
3 Press the [ā²] or [ā¼] key to select [User Login Set.], and press the [OK] key.
2
Configure the setting.
1 Press the [ā²] or [ā¼] key to select [Group Auth.], and press the [OK] key.
2 Press the [ā²] or [ā¼] key to select [Off] or [On], and press the [OK] key.
ā¢ To use the group authorization settings, [Netwk Authentic.] must be selected for the authentication method in
Enabling User Login Administration
on page 9-3. Select "On" for "LDAP" in Protocol Detail on page 8-9.
ā¢ Setting to use group authorization is performed from the operation panel. The groups should be registered with
Embedded Web Server RX. For details, refer to the Embedded Web Server RX User Guide.
If the login user name entry screen appears during operations, enter a login user name
and password, and press [Login].
The factory default login user name and login password are set as shown below.
Sys. Menu/Count.:
User/Job Account
Exit
04
Counter
03
02
System/Network
Login User Name Login Password
4000 4000
To Next Page
Loading...
Need help?
General
