Dive Planning is made on AV1 current settings:
5.7 PO
2
Cells Control mode
(Only for AV1F and AV1 eCCR controller )
AV1F in CCR mode can control PO
2
level in the rebreather loop by means of one, two or
three Oxygen cells of R22, R17 or similar types.
Calibration can be made with any gas: from Air to pure Oxygen.
Calibration range:
Low setpoint 0.40 – 0.95 bar
High and Deco setpoint 1.00 - 1.60 bar
Step - 0.05 bar
Switching between High and Low setpoints can be made both automatically (set depth) and
manually.
At any moment of the dive the whole diveplan with all the forthcoming
decompression stops can be looked through!
To Next Page
Loading...