Time of AV1 independent work depends on the preset screen brightness. Work time will
decrease with higher screen brightness. Screen brightness will be decreased to 30% level
when battery level goes down to 20%.
If the battery is discharged lower than recommended, AV1 will automatically turn off. You will
be able to turn the AV1 on only upon battery charging. Information in the logbook will not be
lost.
Operation time with fully charged battery is about 10 hours.
If you don't use AV1 for a long time, charge it at least once in 2 (two) months. It will prolong
battery life.
Don’t take too much effort when screwing the cap!
The cap is screwed until the tight contact between external O-ring of the cap and the device
body.
Every time ensure that USB-port slot is clean and undamaged. Lubricate O-rings and thread
with silicone grease when required.
2.3 Units of measurement
Both Metric and Imperial units of measurements are used in the decompression meter
(meters and Celsius degrees or feet and Farenheit degrees).
With full battery discharge all the information
(current settings, current tissue saturation) will be lost!
Try not to use AV1 at low temperatures (minus zero C) and keep it in a warm place
right up to the dive.
Try to charge AV1 beforehand – before «lo bat» indicator appears on the screen.
To Next Page
Loading...