VAC D500 - Commissioning Checks; End Position Checks

38
… 8 Commissioning
… Mechanical mounting checks
Moving to end positions after completion of automatic
adjustment
Process dis
p
la
y
1. Use
to switch to the Operating Mode menu.
O
p
eratin
g
mode
Auto Adjust
O Adaptive
O Control
O Manual SP
O Manual Sensor
Configuration
Back O
K
2. Use
or to select the ‘Manual Sensor’ operating mode.
3. Use and to move to the relevant end positions.
-45.0
Pos. Ang.
°
Check
the end positions. The angle of rotation is displayed in
degrees.
Recommended range:
• between Æ30 t
o 30° for linear actuator
• between Æ45 t
o 45° for rotary actu
ator
Moving to end positions with a new device
Process dis
p
la
y
1. Use
and to move to the relevant end positions.
-45.0
Pos. Ang.
°
Check
the end positions. The angle of rotation is displayed in
degrees.
Recommended range:
• between Æ30
and 30° for linear actuat
or
• between
Æ45
and 45° for rotary actuator
Auto Adjust must then be performed.
See Start automatic adjustment on page 43.