VAC D500 - Parameter Descriptions: Display Settings; Language, Units, Display Value, Contrast

58
… 9 Operation
… Parameter descriptions
Menu: Display
Menu / parameter Value range Description
Display
Language English, Deutsch, Français,
Italiano, Español, Português
Selects the menu language
Engineering Units Temperature
Pressure
Universal input
Use this parameter to select the units to be displayed.
• Tem
perature:
°C – degrees Celsius
°F – degrees Fahrenheit
°R – degrees Rankine
K – Kelvin
• Pressure:
ps
i
bar
kPa
Mpa
• Uni
versal input:
The unit can only be entered in plain text using a DTM / EDD.
Display Value Position %
Position °
Setpoint %
Setpoint mA
Deviation %
Temperature
Univ. Inp.
Press. Y1
Press. Y2
Diff. Press.
Supply Press.
Use this parameter to select which value is to be shown on the process display.
• Position % – Position in %
• Position ° – Position in degrees
• Setpoint % – Set point in %
• Setpoint mA – Set point in mA
• Deviation % – Control deviation in %
• Temperature – Device temperature
• Univ. IN – Scaled value at universal input
• Press. Y1 – Pressure output 1
• Press. Y2 – Pressure output 2
• Diff. Press. – Differential pressure between the outputs
• Supply Press. – Supply air pressure
Contrast 0 to 100 % Display contrast