5 Remove the 2 screws from the bottom of the power
unit.
6 Pull the power unit out carefully until the front
lifting holes are available.
7 Attach the lifting hooks to the front lifting holes and
lift the power unit out of the cabinet.
WARNING!
Make sure that the lifting ropes are tight,
and be careful when you lift the power
unit. If the power unit falls off the cabinet
rails and/or swings uncontrollably, it can
cause injury to personnel and/or damage
to equipment.
7.7.5 DOWNLOADING THE SOFTWARE
When it is necessary to get a new version of the software of the drive, obey these
instructions. For more information, speak to the manufacturer.
Before you start to download the software, read these warnings and the warnings in Chapter
2 Safety.
VACON · 108 COMMISSIONING AND ADDITIONAL INSTRUCTIONS
7
LOCAL CONTACTS: HTTP://DRIVES.DANFOSS.COM/DANFOSS-DRIVES/LOCAL-CONTACTS/
To Next Page
Loading...
