6 CONTROL COMPARTMENT
6.1 THE CONTROL COMPARTMENT OF THE ENCLOSED DRIVE
The enclosed drive has a door-mounted control compartment, separated from the cabinet
section, for the mains and motor cable terminals. You can have an access to the control
compartment through a separate door located on the cabinet door.
On the inside of the control compartment door, you can find the order-specific documents.
Make sure that the control cables are long enough to prevent tight bends in the cables
between the control compartment and the frame of the drive.
The control compartment contains these items:
•
the control unit
•
the control panel
•
the option boards
•
the optional auxiliary components and the related wires
•
the terminals for internal connections
•
the terminals for control cabling
•
the order-specific documentation (on the inside of the door)
•
the optional buttons and signal lights (on the door)
Connect the cables of the option boards OPTB2, OPTB4, OPTB5, OPTF3 and OPTF4
(depending on the configuration of the drive) as default to the terminals for control cabling –
XD2 on the control compartment.
Do not connect the cables of the fieldbus boards to the -XD2 terminals, but directly to the
control terminals or the Ethernet terminal on the control unit. Connect the analogue signals
(for example reference signals and temperature signals) and the fieldbus cables directly to
the correct option board.
VACON · 76 CONTROL COMPARTMENT
6
LOCAL CONTACTS: HTTP://DRIVES.DANFOSS.COM/DANFOSS-DRIVES/LOCAL-CONTACTS/
To Next Page
Loading...
