The requirements:
•
+IP54 IP54
•
+CACH Cabinet heater
•
Not +CHCB Back channel cooling
+GAUL: UL LISTED
The product is qualified to the UL criteria.
+GNUL: NOT UL LISTED
The product is not qualified to the UL criteria.
4.6 INSTALLATION OF THE CABINET
Install the AC drive in a vertical position on level ground. Attach the drive with screws to the
wall and/or the floor.
To attach the cabinet to the floor, there are 3 alternatives.
•
Use the 4 fixing points at the bottom of the cabinet.
•
Use the 2 fixing points at the front bottom and the 2 fixing points at the rear top of the
cabinet.
•
Use the 2 fixing points in the fixing bracket and the 2 fixing points at the front bottom of
the cabinet. To use the fixing bracket, first attach it to the floor. Slide the edge of the
cabinet plinth under the fixing bracket. Then attach the 2 fixing points at the front
bottom.
NOTE!
If you have multiple additional cabinet sections (for example with MR12 or the
optional cabling from top), these steps must be done for each section.
MOUNTING VACON · 43
LOCAL CONTACTS: HTTP://DRIVES.DANFOSS.COM/DANFOSS-DRIVES/LOCAL-CONTACTS/
4
To Next Page
Loading...
