Vacon 100 INDUSTRIAL - 6.3.13 Fault History; 6.3.14 Fault History with 16-bit Error Codes

The wiring of the option can be seen in chapter 5.1.1 Main circuit diagrams of the cabinet.
When you use the sine filter option, make sure that the parameter Sine Filter is in use. The
sine filter option is designed for a minimum of 2 kHz switching frequency. Parameter Sine
Filter disables switching frequencies below 2 kHz when automatic derating becomes active.
This option has an overtemperature protection function. The coils of the sine filter have
thermal relays that are connected to the control terminals of the AC drive. The function uses
the terminals +24 Vout (-XD2:12) and digital input 4 (-XD2:14). When the overtemperature
limit is reached, a safety circuit opens and an external fault appears. Find the cause of the
fault. The cause of the fault can be, for example, a fan failure, a clogged air channel, or high
ambient temperature. You can reset the fault after the sine filter has cooled down.
The requirements: Not +PODU du/dt filter.
+CHIT: INPUT CABLING FROM TOP
With this option you can make the input cables, that is, the mains cables enter the cabinet
from the top.
The option includes an additional cabinet section.
+CHOT: OUTPUT CABLING FROM TOP
With this option you can make the output cables, that is, the motor cables enter the cabinet
from the top.
The option includes an additional cabinet section.
+CHCT: CABLING FROM TOP
With this option you can make the cables enter the cabinet from the top.
The option includes an additional cabinet section.
+CHPH: BASE PLINTH 200 MM
This option includes a 200 mm base plinth that you can use instead of the standard 100 mm
base plinth.
+CHCB: BACK CHANNEL COOLING
See more in chapter 4.8 The optional back channel cooling.
The requirements:
•
+CACH Cabinet heater
•
+CAPU Auxiliary AC supply terminals
•
+IP54 IP54
+IP54: IP54
This option provides the enclosure class IP54 for your product.
+EMAR: MARINE CONSTRUCTION
See more information in the Marine Installation Guide.
VACON · 42 MOUNTING
4
LOCAL CONTACTS: HTTP://DRIVES.DANFOSS.COM/DANFOSS-DRIVES/LOCAL-CONTACTS/