Vacon 100 INDUSTRIAL - Maintenance; Maintenance Intervals

2 Find the EMC jumper between the terminals L2 and
L3.
3 Remove the EMC jumper.
4 If you change the EMC level, write "The EMC level
was changed" and the date on the "product
modified" label. If the label is not attached at this
time, attach it on the drive near the name plate.
Product modified
Date:
Date:
Date:
7.7 MAINTENANCE
7.7.1 MAINTENANCE INTERVALS
To make sure that the drive operates correctly and has a long life, we recommend that you
do regular maintenance. Refer to Table 24.
It is not necessary to replace the main capacitors of the drive, because they are a thin film
type capacitors.
WARNING!
Do not make changes in the AC drive when it is connected to mains. The
components of the drive are live when the drive is connected to mains.
COMMISSIONING AND ADDITIONAL INSTRUCTIONS VACON · 91
LOCAL CONTACTS: HTTP://DRIVES.DANFOSS.COM/DANFOSS-DRIVES/LOCAL-CONTACTS/
7