Vacon 100 INDUSTRIAL - 1.2 Warnings

6 Control compartment 76
6.1 The control compartment of the enclosed drive 76
6.2 Fieldbus connection 80
6.2.1 Using fieldbus through an Ethernet cable 80
6.2.2 Using fieldbus through an RS485 cable 81
7 Commissioning and additional instructions 85
7.1 Commissioning safety 85
7.2 Operation of the motor 86
7.2.1 Checks before starting the motor 86
7.3 Measuring the cable and motor insulation 86
7.4 Installation in a marine environment 86
7.5 Installation in a corner-grounded network 87
7.6 Installation in an IT system 87
7.6.1 The EMC jumper in MR8 87
7.6.2 The EMC jumper in MR9 88
7.6.3 The EMC jumper in MR10 and MR12 90
7.7 Maintenance 91
7.7.1 Maintenance intervals 91
7.7.2 Replacing the air filters of the AC drive 92
7.7.3 Replacing the fans of the AC drive 93
7.7.4 Replacing the power unit of the AC drive 99
7.7.5 Downloading the software 108
8 Technical data, VACON
®
100 INDUSTRIAL 112
8.1 AC drive power ratings 112
8.1.1 Mains voltage 380-500 V 112
8.1.2 Mains voltage 525-690 V 113
8.1.3 Brake resistor ratings 113
8.2 VACON
®
100 INDUSTRIAL - technical data 117
9 Technical data, VACON
®
100 FLOW 122
9.1 AC drive power ratings 122
9.1.1 Mains voltage 380-500 V 122
9.1.2 Mains voltage 525-690 V 123
9.2 VACON
®
100 FLOW - technical data 124
10 Technical data on control connections 129
10.1 Technical data on control connections 129
VACON · 6 TABLE OF CONTENTS
LOCAL CONTACTS: HTTP://DRIVES.DANFOSS.COM/DANFOSS-DRIVES/LOCAL-CONTACTS/