Vacon 100 INDUSTRIAL - Page 67

5.4 CABLE INSTALLATION IN MR8-MR12
A
B
D
E
F
G
H
I
J
K
L
M
N
C
P
O
Fig. 35: The inside layout of MR8, without protective covers
A. The output air grill
B. The control connector of the power unit
C. The EMC jumpers
D. The contactor option
E. The main switch option and the fuses
F. The mains cable terminals
G. The 360-degree grounding
H. The PE bar
I. Input air grill
J. The terminals for the option +CAPU
K. The motor cable terminals with the
common mode and/or the du/dt filter
options
L. The options CAPT and CPIF
M. The motor cable terminals, without the
common mode and/or the du/dt filter
options
N. The internal fan for IP54
O. The main fan
P. The cable entry plate for control cables
POWER CABLING VACON · 67
LOCAL CONTACTS: HTTP://DRIVES.DANFOSS.COM/DANFOSS-DRIVES/LOCAL-CONTACTS/
5