Vacon 100 INDUSTRIAL - Page 79

G. The control grounding plate
H. The customer grounding plate
I. The terminals for control cabling
(default)
J. Grounding clamps for cable shield
CBA
D
I
K
L
M
N
O
P
Q
R
J
E
G H
F
Fig. 42: The control compartment components of the cabinet
A. The insulation fault sensor (+CPIF)
B. The 24 VDC power supply (+CAPD)
C. The emergency stop Cat 1 (+CPS1)
D. The MCBs for auxiliary devices
E. The control unit
F. The 230 VAC socket (+CAPS)
G. The extended I/O terminals (+CTID) to be
used freely
H. The terminals for control cabling
(default)
I. The control panel
J. The emergency stop push button
(+CPS0, +CPS1, +CPSB)
K. The emergency stop reset button
(+CPS1)
L. The Fault signal light (+CDLP)
M. The Run signal light (+CDLP)
N. The Ready signal light (+CDLP)
O. The Reset button (+CDLP)
P. The 0 - 1 - start switch (+CICO)
Q. The insulation fault (+CPIF)
R. The rating plate of the drive, the option
codes and the serial number
CONTROL COMPARTMENT VACON · 79
LOCAL CONTACTS: HTTP://DRIVES.DANFOSS.COM/DANFOSS-DRIVES/LOCAL-CONTACTS/
6