Vacon 100 INDUSTRIAL - Page 89

2 Loosen the screws of the cover plate and remove it.
3 Remove the EMC jumper.
4 If you change the EMC level, write "The EMC level
was changed" and the date on the "product
changed" label. If the label is not attached at this
time, attach it on the drive near the name plate.
Product modified
Date:
Date:
Date:
THE EMC JUMPERS 2 AND 3
1 Remove the cover of the extension box, the touch
shield, and the I/O plate with the I/O grommet
plate.
COMMISSIONING AND ADDITIONAL INSTRUCTIONS VACON · 89
LOCAL CONTACTS: HTTP://DRIVES.DANFOSS.COM/DANFOSS-DRIVES/LOCAL-CONTACTS/
7