Vacon NXL 0023 5 - Page 66

66(80) Control keypad vacon
Vacon Oyj Telephone: +358-201-2121 Fax: +358-201-212 205
24-hour support: +358-40-8371 150 Email: vacon@vacon.com
7
Example: When you want to reset the operation counters, you should do the following:
Figure 7-15. MWh counter reset
Software info submenu (S6.8.3)
The following information can be found under the Software info submenu (S6.8.3):
Page Content
I6.8.3.1 Software package
I6.8.3.2 System software version
I6.8.3.3 Firmware interface
I6.8.3.4 System load
Table 7-8. Software information pages
Application information submenu (S6.8.4)
You can find the following information from the Application info submenu (S6.8.4)
Page Content
A6.8.4.1 Application
D6.8.4.1.1 Application id
D6.8.4.1.2 Version
D6.8.4.1.3 Firmware interface
Table 7-9. Application information pages
Hardware information submenu (S6.8.5)
You can find the following information from the Hardware info submenu (S6.8.5)
Page Content
I6.8.5.2 Unit voltage
I6.8.5.3 Brake chopper
I6.8.5.4 Brake resistor
Table 7-10. Hardware information pages