vacon Control keypad 65(80)
Vacon Oyj Telephone: +358-201-2121 Fax: +358-201-212 205
24-hour support: +358-40-8371 150 Email: vacon@vacon.com
7
Number of retries to receive HMI acknowledgement (P6.7.4)
With this parameter you can set the number of times the drive will try receive acknowledgement if
this does not succeed within the acknowledgement time (P6.7.3)
Enter the edit mode by pushing the Menu button right. The present value shown starts to blink. Use the
Browser buttons to change the amount of retries. Accept the change with the Enter button or return to the
previous level with the Menu button left.
7.3.6.5 System information
In the submenu S6.8 under the System menu you can find frequency converter-related hardware
and software information as well as operation-related information.
Enter the Info menu by pressing the Menu button right. Now you can browse through the
information pages with the Browser buttons.
Counters submenu (S6.8.1)
In the Counters submenu (S6.8.1) you can find information related to the frequency converter operation
times, i.e. the total numbers of MWh, operation days and operation hours passed so far. Unlike the counters
in the trip counters menu, these counters cannot be reset.
Note! The operation time counter (days and hours) runs always, when the power is on.
Page Counter
C6.8.1.1 MWh counter
C6.8.1.2 Operation day counter
C6.8.1.3 Operation hour counter
Table 7-6. Counter pages
Trip counters submenu (S6.8.2)
Trip counters (menu S6.8.2) are counters the values of which can be reset i.e. restored to zero. You
have the following resettable counters at your disposal:
Note! The trip counters run only when the motor is running.
Page Counter
T6.8.2.1 MWh counter
P6.8.2.2 Clear mWh counter
T6.8.2.3 Operation day counter
T6.8.2.4 Operation hour counter
P6.8.2.5 Clear operation time counter
Table 7-7. Trip counter pages
To Next Page
Loading...
