Vacon NXL 0023 5 - Copy Parameters

vacon Control keypad 61(80)
Vacon Oyj Telephone: +358-201-2121 Fax: +358-201-212 205
24-hour support: +358-40-8371 150 Email: vacon@vacon.com
7
7.3.6.1 Copy parameters
The Copy parameters submenu (S6.3) is located under the System menu.
The Vacon NX frequency converter features a possibility for the user to store and load two
customised parameter sets (all parameters included in the application) and to load back the factory
default parameter values.
Parameter sets (S6.3.1)
On Parameter sets page (S6.3.1), push the Menu button right to enter the Edit menu. You can store
or load two customised parameter sets or load back the factory defaults. Confirm with the Enter
button. Wait, until 8 (=OK) appears on the display.
Figure 7-10. Storing and loading of parameter sets
7.3.6.2 Security
The Security submenu (S6.5) under the system menu has a function that allows the user to prohibit
changes to the parameters.
Parameter lock (P6.5.2)
If the parameter lock is activated the parameter values cannot be edited.
NOTE: This function does not prevent unauthorised editing of parameter values.
Enter the edit mode by pushing the Menu button right. Use the Browser buttons to change the
parameter lock status (0 = changes enabled, 1 = changes disabled). Accept the change with the
Enter button or return to the previous level with the Menu button left.
enter
ST OP I/O term
READY
ST OP I/O term
READY
nxlk21 .fh 8
ST OP I/O term
READY
ST OP I/O term
READY