Vacon NXL 0023 5 - Navigation on the control keypad

44(80) Control keypad vacon
Vacon Oyj Telephone: +358-201-2121 Fax: +358-201-212 205
24-hour support: +358-40-8371 150 Email: vacon@vacon.com
7
= Menu button left
Move backward in menu.
Move cursor left (in parameter edit mode).
Exit edit mode.
Hold down for 2…3 seconds to return to main menu.
= Menu button right
Move forward in menu.
Move cursor right (in parameter edit mode).
Enter edit mode.
= Start button.
Pressing this button starts the motor if the keypad is the active control place.
See Chapter 7.3.3.1.
= Stop button.
Pressing this button stops the motor (unless disabled by parameter
R3.4/R3.6).
7.3
Navigation on the control keypad
The data on the control keypad are arranged in menus and submenus. The menus are used for
example for the display and editing of measurement and control signals, parameter settings
(chapter 7.3.2), reference values and fault displays (chapter 7.3.4).
The first menu level consists of menus M1 to E7 and is called the Main menu. The user can
navigate in the main menu using the Browser buttons up and down. The desired submenu can be
entered from the main menu using the Menu buttons. When there still are pages to enter under the
currently displayed menu or page, the last digit of the figure on the display is blinking and by
pressing the Menu button right, you can reach the next menu level.
The control keypad navigation chart is shown on page 46. Please note that the menu M1 is located
in the lower left corner. From there you will be able to navigate your way up to the desired menu
using the menu and browser buttons.
More detailed descriptions of the menus you will find later in this Chapter.
3
33
3
4
44
4
start
stop
Location