42(80) Control keypad vacon
Vacon Oyj Telephone: +358-201-2121 Fax: +358-201-212 205
24-hour support: +358-40-8371 150 Email: vacon@vacon.com
7
READY = Lights when AC power is on. In case of a fault, the symbol will not light up.
ALARM = Indicates that the drive is running outside a certain limit and a warning is given.
FAULT = Indicates that unsafe operating conditions were encountered due to which the drive was
stopped.
7.1.2
Control place indications (See control keypad)
The symbols I/O term, Keypad and Bus/Comm (see chapter 7.3.3.1) indicate the choice of
control place made in the Keypad control menu (see chapter 7.3.3).
I/O term = I/O terminals are the selected control place; i.e. START/STOP commands
or reference values etc. are given through the I/O terminals.
Keypad = Control keypad is the selected control place; i.e. the motor can be started
or stopped, or its reference values etc. altered from the keypad.
Bus/Comm = The frequency converter is controlled through a fieldbus.
7.1.3 Numeric indications (See control keypad)
The numeric indications provide the user with information on his present location in the keypad
menu structure as well as with information related to the operation of the drive.
4
5
6
To Next Page
Loading...
