Vacon nxs - Page 7

7.9 Using the System menu (M6) 91
7.9.1 Changing the language 95
7.9.2 Changing the application 95
7.9.3 Copy parameters (S6.3) 96
7.9.4 Comparing the parameters 99
7.9.5 Security 101
7.9.6 Keypad settings 105
7.9.7 Hardware settings 107
7.9.8 System info 112
7.10 Using the Expander board menu (M7) 117
7.10.1 Examining the connected expander boards 118
7.10.2 Finding the expander board parameters 119
7.11 Further keypad functions 120
8 Commissioning and additional instructions 121
8.1 Commissioning safety 121
8.2 Commissioning of the drive 122
8.3 Operation of the motor 122
8.3.1 Checks before starting the motor 122
8.3.2 The Run test without the motor 123
8.3.3 Start-up test 123
8.3.4 Identification run 123
8.3.5 Connecting the motor to the process 123
8.4 Measuring the cable and motor insulation 124
8.5 Installation in an IT system 124
8.5.1 Frames FR4, FR5, and FR6 124
8.5.2 Frame FR7 125
8.5.3 Frames FR8 - FR11 127
8.6 Maintenance 127
8.6.1 Capacitor reforming 128
9 Technical data for NXS and NXP 129
9.1 AC drive power ratings 129
9.1.1 Mains voltage 208-240 V 129
9.1.2 Mains voltage 380-500 V 131
9.1.3 Mains voltage 500–690 V 133
9.1.4 Overload capability 135
9.1.5 Brake resistor ratings 136
9.2 Vacon
®
NXS and NXP - technical data 140
9.3 The compliance with the product standard IEC/EN 61800-3 + A1 145
9.3.1 Environment definitions in product standard IEC/EN 61800-3 + A1 147
10 Fault tracing 148
10.1 Resetting a fault 148
10.2 Fault codes 150
11 Appendix 1 157
11.1 Power losses for 380-500 V 157
11.2 Power losses of 500-690 V 162
TABLE OF CONTENTS VACON · 7
24-HOUR SUPPORT +358 (0)201 212 575 · EMAIL: VACON@VACON.COM