Vaisala HMT360Series - Transmitter Mounting

Installation ________________________________________________________________________
Vaisala _________________________________________________________________________ 13
Mounting the transmitter
FIGURE 3-1 Mounting the transmitter and detaching the probe
FIGURE 3-2 Different parts of the transmitter
1. Attach the mounting
plate to the wall with 4
screws.
2. Press down the
transmitter so that it
slides along the rails of
the mounting plate.
3. Fasten the transmitter
to the mounting plate
with the Allen screw.*
4. The probe can be
detached and replaced
when needed by simply
unfastening the two
Allen screws.
* 3 mm Allen key
provided
1. electronics unit
2. transmitter base
3. probe; including a part o
f
measurement electronics
(e.g. calibration memory
and the sensor head)
4. protective covers
5. flat cable
6. sensor head
7. cable glands
8. grounding terminals
9. RS232 connector
8
7
9