Compa II series Installation
07.15 Operating manual 25
4 Installation
Lift the label printer out of the box.
Check the label printer for transport damages.
Check delivery for completeness.
Label printer.
Power cable.
Empty core, mounted on transfer ribbon rewinder.
Tear-off edge (basic printers only).
Dispenser edge (printers with option dispenser only).
Cutter unit (printers with option cutter only).
Documentation.
Printer driver on CD ROM.
Labelstar Office LITE on CD ROM
NOTICE!
Retain original packaging for subsequent transport.
4.1 Setting up the label printer
CAUTION!
The label printer and the print media can be damaged by
moisture and water.
Set up the label printer only in a dry place protected
from sprayed water.
Set up label printer on a level, vibration-free and air draught-free
surface.
Open cover of label printer.
Remove foam transportation safeguards near the printhead.
Unpack the
label printer
Scope of delivery
To Next Page
Loading...
