Options Compa II series
60 Operating manual 07.15
Select the desired cutter operating mode, then press key
to
select additional functions.
When using this function, after the first cut a feed with the set offset is
effected and then cut anew. After the cut a back feed to the printing
position is effected.
Press key
to arrive the next menu item.
Automatic: After each printed label a cut is released.
Extern: A cut is released by an external I/O. External can only be
selected if the label printer is equipped with option external I/O Nach
jedem gedruckten Etikett wird ein Schnitt ausgelöst.
Press key
to arrive the next menu item.
On: The label is pulled back immediately after the cut.
Off: The label is pulled back only before the next print.
In case you are in the main menu or a print order has been stopped
you can release a single cut by pressing key
.
The type of the single cut depends on the set cutter mode, offset and
the value set for the double cut.
Double cut
Cutter control
Automatic return
Single cut
To Next Page
Loading...
