Valeton CP-200 User Manual

Send
Return
Series Parallel
Send
Return
Save Menu
In the Save menu, you can save the changes you make to your eects parameters, control information, and other
editable targets.
When pressing SAVE button, the interface will enter Save Menu (see picture 1 below), choose a slot via rotating and
pressing PARA. Press it to enter Rename Menu (see picture 2 below).
In the Rename Menu, you can manage your editing through PARA knob or 3 Quick Access Knobs.
Ÿ Quick Access Knob 1: There are 4 types of characters to choose from: Uppercase, lowercase, numbers and symbols
(including space).
Ÿ Quick Access Knob 2: Switch the position of the icon.
Ÿ Quick Access Knob 3: Delete the icon targeted character.
Ÿ When finishing, press SAVE to make sure you saved.
Ÿ Click BACK to exit editing and return to the previous menu.
Remember to save after finishing the editing.
Global Settings
Global Settings, unlike previous ones, will aect the whole status of the GP-200 and not change when the patch has
changed. All the settings will immediately function when editing is finished. There are input/output, USB Audio,
footswitch/EXP pedal, language and more in this menu, as well as factory reset.
9
Ÿ FX Loop: Eects loop’s settings in the current selected patch. The send and return are stationed after the AMP
module. Parallel/Series illustrates how the eects loop is connected to the signal chain.
◦ When set to Parallel, the returned signal from external eect chains will mix with the AMP module and be sent to
the latter signals in the signal chain.
◦ When set to Series, internal eect chain will be temporarily paused, only signals from external eect chains will
be sent to the latter signals in the signal chain. In this situation, if the eect loop interface is not connected to the
any other eect unit, the GP-200 output will remain silent.
SAVE
Rotate PARA to move the cursor, press to select
SAVE
Use PARA or knob 1~3 to edit. Press SAVE button to save.
Knob1 Knob2 Knob3
Letter Cursor Delete
Patch Setting

Valeton CP-200 Specifications

Audio Specifications

A/D/A Converter	24-bit high performance audio
Sampling Frequency	44.1 kHz
Signal-to-Noise Ratio (SNR)	110 dB

Memory and Recording

Patch Memory	256 Patch slots, 100 Factory Patches
Looper Record Time	180 seconds
Drum Machine Patterns	100 Patterns

Connections

MIDI Connectors	5-pin MIDI (IN/OUT/THRU)
USB Port	USB 2.0 Type-C
Guitar Input	1/4″ Unbalanced (TS)

Analog Input Specifications

Input Impedance (A.GT)	1M Ohms
Input Impedance (E.GT)	4.7M Ohms
Input Impedance (Line)	10k Ohms

Analog Output Specifications

L/R Unbalanced Output Impedance	1k Ohms
L/R Balanced Outputs	XLR jacks
Headphone Output Impedance	22 Ohms

USB Recording Specification

USB Sample Rate	44.1 kHz
USB Bit Depth	Supports 16-bit or 24-bit
USB Port	USB 2.0 Type-C

Size and Weight

Dimensions	345mm(W) x 220mm(D) x 62.5mm(H)
Unit Weight	2.37 kg
Power Requirements	DC 9V, 1000mA