HBDBD9(B;>>p
D:?
< (BK$;B,
($BB<r
D ,%%B%$$,B(r7%D$B
%$$,9$:
The following chapters describe the individual basic differences in starting. The accelerator lever positions (>=+K, ?="),
@=l, and A=KI8) are described in
D:
. All the four main positions described are locked by a simple, dip-protrusion system in
the lever body. The functions of the individual switch buttons (+K , > and +lm+) on the start panel are described in
D:A
.
2.4.2.1.1 ELECTRIC STARTER ENGINE
Modern and also the easiest way of engine starting. The battery also serves as a key to the machine and is also a safety device against
any accidental engine start.
+BD(FB$$,(,BB$%BD:
+BD(FB
ot
(,:
+BD%%~$D$:
%,D9B&B(%B(BB% B
D$BD:
1.
D:A
- On the starting panel, there press the middle button marked >.
2. Press the DB( marked +lm+ and hold it for max. 5 seconds, till the electric starter starts the engine
p
, then release
the button.
7,D,DDrE ,,B:
7B Br
2.4.2.1.2 MECHANICAL CHOKE ENGINE
1. Move the accelerator lever per
D:
to its position A KI8.
,F DFBB@l$:
2. Start the engine by pulling on the hand starter cord
p>
.
3. Let a new or cold engine run for about 30 seconds with the choke engaged (accelerator lever in its A KI8$), then
move the accelerator lever to @l.
7B Br
2.4.2.1.3 AUTOMATIC CHOKE ENGINE
1. Move the accelerator lever per
D:
to $@ l.
2. Start the engine by pulling on the hand starter cord
p?
.
3. The automatic choke, once the engine is warmed up
p@
, will adjust the engine speed.
7B Br
2.4.2.2 WORKING TOOL START
,%B B9B&BDBD%B(%DBF&B
B(%B%, 99Dr
&B$9B9 l8% B BrKBF9
,%,r
1) Start the engine
pA
. If the engine is cold, let it warm up at its maximum speed for approx. 1 minute.
2) Grab the left handle of the handlebar with your left hand. With your right hand move (lift), following
D:p
, the DB control
lever > to its upper position, so it is fully inserted into $FB( ?.
3) Press &D( @ on strap with cables ? in the arrow direction. Hold the button till the control lever moves
downwards to the handle and locks (
D:
) and starts moving the strap with cables.
F,$BB$$~ ,FB%9BF&D$D9
BD$:
4) Once the working tool starts spinning, push the lever fully to the handle, to its working position (
D:t
), and hold it firmly.
69
Battery charging is described in the engine operating instructions.
70
Wait for 1 minute between start cycles.
71
The engine startup instructions are described in detail in the engine operating instructions.
72
The engine startup instructions are described in detail in the engine operating instructions.
73
Depending on the ambient temperature and engine temperature, the automatic choke is activated for about 1 minute.
74
The engine startup instructions are described in detail in the engine operating instructions.
?p
Revize 10/2019