VAT 64246-UEHC-0001 - Display Information; Power up

Series 642
OPERATION
603685EA
Edition 2013-08-22
45/73
5.6 Display information
There is a 4 digit display located on
the panel. It displays configuration,
status and position information. For
details see following tables.
5.6.1 Power up
Description
Digit 1
Digit 2
Digit 3
Digit 4
At first all dots are illuminated then
configuration is displayed:
- Firmware version [e.g. 1E00]
(1st information for about 2s)
- Controller configuration
(2nd information for about 2s)
SYNC indicates that power up
synchronization is running.
In case D C or D999 is displayed,
motor interlock is active. Refer to
«Safety mode» for details.
If valve is closed (isolated) display
shows alternately C C and INIT.
Syncronization will be done when
first movement command is
received.
1
E
0
0
1
= Logic interface
0
= basic
1
= with SPS
1)
2
= with PFO
2)
3
= with SPS
1)
and
PFO
2)
1
= 1 sensor version
2
= 2 sensor version
S
Y
N
C
1) SPS = optional ±15 VDC Sensor Power Supply module 2) PFO = Power Failure Option
Display
1 2 3 4