9. Installing Software
128 vatech A9 (Model:PHT-30CSS) Installation Manual
Disabling the Packing Mode
vatech A9 has the Packing Mode built into the system to
prevent the unit from being damaged while shipping and
transporting. Since the mode is automatically turned on upon
shipping, the installer must disable the Packing Mode before
turning on the equipment.
The equipment does not operate even after the power is
turned on if the packing mode is not properly disabled.
1. Click on the General Tab on the Control Panel.
2. The Networking option enables the Ethernet checkbox and sets Ethernet IP
and Port as below and then click Manager.
3. Enter the command PVER] to verify the current mode. Note that the equipment is now
in packing mode.
To Next Page
Loading...
