2. Warnings and Precautions
10
I
PaX-i3D Smart
● DO NOT place the PC or peripheral equipment connected to the PC in the
immediate vicinity of the patient.
● The equipment and PC should be connected to a common protective earth.
● Never overload the equipment’s circuit by sharing it with too many appliances.
● Use the same power circuit for the PC and the equipment.
❚
Combining this equipment with other devices
● Do not connect this equipment to devices which are not part of the system.
● Do not connect this equipment to a Multiple Portable Socket-Outlet (MPSO) or
extension cord.
❚
Electromagnetic compatibility
● This equipment complies with IEC standard 60601-1-2.
Medical electrical equipment is subject to special EMC preventive measures. It must be installed
and operated as specified in the Installation Requirements document.
If high-voltage systems, radio link systems or MRI systems are located within 5 m of the unit,
please observe the specifications stated in the installation requirements.
Portable and mobile RF communications equipment may interfere with medical electrical
equipment. Therefore, the use of mobile wireless phones in medical offices or hospital
environments must be prohibited.
For more details, refer to the document Electromagnetic Compatibility Information.
Please also observe the ESD (ESD: Electro-Static Discharge) protective measures described
below.
❚
Static Discharge
● Connector pins or sockets bearing ESD warning labels must not be touched or
interconnected without observing ESD protective measures.
Electrostatic discharge (ESD)
To Next Page
Loading...
Need help?
General
