POS App Guide DIM Installation Examples
34
Wayne Dispensing Systems
TLS CONSOLE SOFTWARE REQUIREMENTS
TLS-350R with BIR Software Requirements
• System software Version 17 (or higher)
• Peripheral controller software 330269-00B (or higher)
TLS-450/TLS-450PLUS with BIR Software Requirements
• TLS-450 System software Version 2.x (or higher)
• TLS-450PLUS System software Version 6.x (or higher)
• BIR option required (TLS-450)
VEEDER-ROOT HARDWARE REQUIREMENTS
The required DIMs and installation kits for use with Wayne Dispensing systems are listed in Table 2 on page 7.
POS SYSTEM REQUIREMENTS AND LIMITATIONS
Current Loop Installations (TLS-350R/ TLS-450/TLS-450PLUS)
• A Wayne site controller and Wayne dispensers are required.
• Any POS system may be connected to the Wayne site controller.
• The dispensers may feature electronic card readers.
TDIM Installations
• Wayne IDPOS dispenser software 2.29 (TLS-350R and TLS-450)
SUPPORTED WAYNE SYSTEMS
• Wayne 186 System with Site Controller model 880179-001 and Dispenser Data Box (CAB) model DD/
SY2400/08.
• Wayne 386 System with Site Controller model WP/SC and Dispenser Data Box (CAB) model WP/DD.
SUPPORTED WAYNE POS TERMINALS
• Wayne 186 based 2400
• Wayne 186 based Plus 2
• Wayne 186 based Plus 3
• Wayne 386
In addition, third party POS vendors supply POS systems that interface to Wayne Site Controllers and dispensers.
The Wayne DIM supports POS systems that interface to the Site Controller using a Wayne Pump Interface Board
(PIB). A partial list of these systems include:
• GasBoy
•Omron
• Panasonic
• S.A.S.I.
•Suntronics
•Verifone
•EDS C-Serve
The third party POS system will be supported by the Veeder-Root DIM if it communicates to the Wayne Site
Controller using the Wayne PIB.
To Next Page
Loading...
Need help?
General
