Veeder-Root TLS-IB User Manual

TLS-IB Site Prep Manual Mounting the TLS-IB
14
Mounting the TLS-IB
Install the TLS-IB fastening devices to the m ounting surface using the hole pattern 170 x 145mm (6.7 x 5.7 inches)
shown in Figure 12. Mounting screws up to 4.7mm (3/16-inch) diameter may be used.
Mount th e TL S-IB to the m ounting surface using the f our mounting flanges on the back of the unit. Install ducting or
conduit between the TLS-IB and the power panel. Figure 12 shows the three designated knockouts (one each on top, left
side, and bottom ) through which power wiring can safely enter the TLS-IB.
Figure 12. TLS-IB Dimensions and Designated Conduit Knockouts
0.34'' (8,6) typ.
0.34'' (8,6) typ.
7.4" (188)
6.4''
(163)
5.7''
(145)
2" (50)
5.3'' (135)
1.24''
(31)
5.3'' (135)
0.54" inside (M12 conduit),
1/2'' I.P.S. (International Pipe Size) outside (PG7 conduit)
knockouts 4 places - bottom (2), left side (1), and top (1)
1/2", 3/4'', & 1'' I.P.S.
conduit knockout pattern (2 place
s)
Cover (shown open
for reference)
tlsnt\ibdim.eps
0.22'' (5,6) dia.
mounting holes (4 places)
0.93'' (23)
0.93'' (23)
3''
(73)
0
.7''
(
17)
0.93''
(23)
6.7" (170)
NOTE: Numbers
in parenthesis are
in millimetres.
0.93''
(23)

Veeder-Root TLS-IB Specifications

General

Brand	Veeder-Root
Model	TLS-IB
Category	Control Systems
Language	English