EasyManua.ls Logo

Vega SHLD 2 - Configuration and Labels

Vega SHLD 2
88 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
14 63138-US-200110
Pneumatic switching facility: (With pneumatically actuated source containers)
For use in hazardous areas of category ATEX II 2G, note the corresponding
safety instructions.
Corrosion: Do not use the pneumatic actuation under ambient conditions that
can cause corrosion in and on the pneumatic actuator.
2.8 Applications
Intended Applications
The SHLD 2 source holder is designed for radiation-based measurement of
applications including density and continuous and point level. The most common
industries for the SHLD 2 include:
Chemical
Petrochemical
Offshore
Refining
2.9 Certifications
These source holders are designed for certification compliance from the
following agencies:
AERB - India (B, C, and R only)
CNSC - Canada
ODH/NRC - Ohio Department of Health and Nuclear Regulatory
Commission
Standards
The SHLD 2 source holders is regulated by the U.S. Nuclear Regulatory
Commission (NRC). Compliance certificates are issued by the State of Ohio
under an agreement with the NRC.
2.10 Manufacturer's Responsibility
VEGA source holders are designed to International standards for construction
and safety.
2.11 User's Responsibility
All users who operate and service the equipment are responsible for ensuring
safety requirements are met. This responsibility requires a basic understanding
of the nature of radiation and an adherence to all operating procedures.

Table of Contents

Related product manuals