Vega SHLD 2 - Mounting with a Crane

26 63138-US-200110
The following mounting instructions are specific to the SHLD 2.
•
For mounting of the SHLD 2, you need a special handling permit.
•
Only authorized, qualified pesonnel
who are monitored for radiation
exposure according to local
la ws or the handling permit, may mount the
source holder.
Ta k e note of the specifications in the handling permit. Also
take the local conditions into account.
• Carry out all work within the shortest possible time and at the largest
possible distance.
• Provide suitable shielding
• Avoid risk to other people by taking suitable measures such as a safety
fence, when mounting the source holder.
• Depending on the version, the center of gravity of the SHLD 2 can
vary.
Keep this in mind during crane transport on the lug.
Mounting with a Cr ane
The source holder is screwed onto a transport board. Loosen the screws and lift
the source holder from the transport board. Make sure you use the lug when moving
the SHLD 2.
Use suitable lifting equipment (chain, snap hook, etc.) to fasten the source holder
to the crane hook. Keep in mind that the source holder will tilt to the side while you
are lifting it.
Check
the hoisting equipment f or sufficient lifting capacity,
which is approximately 330 lbs(150 kg).
Never allow anyone to stand beneath the loads.
!
WARNING