63138-US-200110 35
Screw Locking Mechanism
The source holder must be integrated in the potential equalization of the system.
To ensure a good electrical contact between the source holder and the mounting
bracket, you must use the supplied lock washers to the following illustration.
Use the prescribed torque for the mounting screws (M10). Make sure that the
screws have electrical contact to the potential equalization.
Figure 4.8
Lock Washers and Conductive Connection
1. Lock Washers (2 pcs.) - provided by customer
In conjunction with WeighTrac: Retaining washers Nordlock (2 pcs.) - in the scope of delivery
Material Strength Class Torque
Stainless Steel 70 32 Nm
Steel 8.8 50 Nm
To Next Page
Loading...
