30 63138-US-200110
Density Orientation
Achieve the optimum and most constant conditions for density measurement in
pipes by mounting the measuring equipment on vertical pipelines or con
veyors
.
Orient the radiation directly towards the detector mounted on the opposite side.
To extend the distance the beam travels through the medium and thus achieve a
better measuring effect, radiate the tube diagonally
or use a measuring track.
Find the required mounting accessories in the chapter "Supplemental-Info".
Mount the source holder SHLD 2 as close as possible to the vessel.
However, with large measuring ranges and small vessel diameters, a gap can
often is not avoidable
.
If there are gaps or empty spaces around the installation, provide protective
fences or grids to keep hands away from the dangerous
area.
You must mark
such areas accordingly.
The ideal measurement setup for density measurement is installation on a vertical
pipeline.
Make sure the pipe diameter is at least 1.97 in (50 mm) and the flow direction is
from bottom to top.
Mounting brackets, angled attachments as well as mounting clamps are available
for mounting.
To Next Page
Loading...
