VEMAG HP30E - Page 6

HP25E / HP30EIndex
iv © VEMAG 2018
8.5 Daily maintenance 8-8
8.5.1 Feed unit seals (lubrication) 8-8
8.6 Weekly maintenance 8-10
8.6.1 Feed unit drive (lubrication) 8-10
8.6.2 Intake (air lter) 8-11
8.6.3 Vacuum pump (air lter) 8-12
8.6.4 Vacuum pump 40 m³ 8-12
8.7 Monthly maintenance 8-13
8.7.1 Double screw drive (oil level and seals) 8-13
8.7.2 Vacuum pump 40 m³ 8-13
8.8 Six-monthly maintenance 8-14
8.8.1 Feed unit seals 8-14
8.8.2 Hydraulic unit (oil level) 8-14
8.8.3 Vacuum pump 40 m³ 8-14
8.9 Annual maintenance 8-15
8.9.1 Feed unit drive and feed unit seals 8-15
8.9.2 Hydraulic unit (oil change) 8-15
8.9.3 Vacuum pump 40 m³ 8-16
8.9.4 Double screw drive (oil change) 8-18
8.10 Biennial maintenance 8-19
8.10.1 Double screw drive 8-19
8.11 Three-yearly maintenance 8-20
8.11.1 Feed drive (oil change) 8-20
9. Troubleshooting 9-1
9.1 General information 9-1
9.2 Troubleshooting table 9-1
10. Appendix 10-1
10.1 General information 10-1
10.2 Technical data HP25E / HP30E 10-2
10.3 Dimensional drawings HP25E / HP30E 10-3
10.4 Hydraulic plan 10-4
10.5 Lubricants 10-5
10.5.1 Double screw drive 10-5
10.5.2 Feed drive 10-5
10.5.3 Hydraulic unit lifting and tipping device (optional) 10-5
10.5.4 Vacuum pump 10-5
10.5.5 Feed unit seals and feed unit drive 10-5
10.5.6 Individual parts 10-5
10.6 Accessories 10-6
10.6.1 Double screw selection 10-6
10.6.2 Filling horn selection 10-7
10.6.3 Linking horns 10-7
10.6.4 Miscellaneous accessories 10-8
10.6.5 Tools 10-8
10.7 Disposal 10-9
10.7.1 General information 10-9
10.7.2 Proper disposal 10-9