C-2
Part #1169256 09/2008
READING A PARTS LIST
I ITEM NUMBER is found in two locations:
A. It is on the drawing plate, and identifi es the part and its location;
B. The same number is in the parts lists and ties the two together.
II PART NUMBER is the part number that has been assigned to a specifi c part by
SandenVendo America, Inc., for easier identifi cation.
III QUANTITY REQUIRED relates to the amount required of a part, or will be
indicated by “A/R” (as required) to attach it to another part.
IV PART NAME AND DESCRIPTION is the general description for the part, for
easier identifi cation when ordering a like part.
V HARDWARE is identifi ed by a letter in a hexagon. Refer to hardware list section
or description and part numbers. See pages C-4 and C-5.
The example below will show how the parts are listed in the parts lists:
1. VEND MOTOR ASSEMBLY: This is the main assembly name, and any
replaceable parts will be indented below the assembly.
2. RETAINER CAM: This is an individual part, and will be indented. These indented
parts can be ordered separately, so you do not need to order the entire assembly.
3. Whenever an assembly is ordered, all the parts that are indented will be included
in the assembly. Any hardware will be listed next to their corresponding parts.
4. Any parts that may be ordered separately will not have any indented parts listed
below them.
If an asterisk is listed below the parts list, it is an indication that special information is
noted. There may be more than one asterisk (*) (**) (***) denoting special notes.
ITEM
NO
DESCRIPTION QTY
REQ
PART NO.
1 VEND MOTOR ASSEMBLY ~ 1115821
2 RETAINER CAM 1 1113244
3 TIMING CAM 1 1113236
To Next Page
Loading...
