P-2
Part #1169256 08/2010
VEC 12.4 PROGRAMMING OPERATION
NOTE: Some units may contain a European font display, in which case the “°” symbol will
be replaced by the “ß” symbol. Example: 72°F will be 72 ß F.
The VEC 12.4 Controller uses a 4-button programming system:
Programming Buttons: # 1 – Escape/Exit
# 2 – Decrease/Scroll Down
# 3 – Increase/Scroll Up
# 4 – Enter and/or Save
To access Mode functions, open the door. Locate the Mode Button on the Main Control Board
and press until Diagnostics appears. Use selection button 2 or 3 to navigate through the modes.
The Modes are as follows:
Diagnostics
Coin Payout
Tube Fill
Test Mode
Cash Data
Sales Data
Set Price
Set Depth
Confi guration
Space to Sales
Set Program Password
Set Language
Set Clock *
Lighting *
Refrigeration **
Sales Block 1 *
Sales Block 2 *
Discount *
Override **
Return
noC ni ”erutaeF gnimiT“ eht nehw raeppa ylno lliw sedom esehT * fi guration is turned On.
** Limited options appear in this mode depending on whether the Timing Feature in
Confi guration is On/Off.
To Next Page
Loading...
