Vendo VUE 30 - Page 139

Start
Prerequisites:
X-
Rail level, door ramp,
trays seated, door/Cab
level, latches,
Y Rail stop (hinge side)
loose and down.
Power to Cabinet:
Make harness connections
(light, door) to power
supply.
Plug VAC cord in.
Once hand goes to home
position disconnect Y
Motor power connector.
Close and latch door.
Adjust Y Home stop, latch
side where Amber LED is
OFF.
Adjust Y Home magnet to
overlap sensor by approx.
0.100". Reference only.
A
A
Activate Test Mode,
Sensor Status.
Is Y
sensor
act
ive
NO
YES
Install 0.250"
spacers. Reset the
Is Y
sensor
inactive
NO
YES
Install 0.075"
spacers. Reset the
sensor status.
Is Y
sensor
active
NO
YES
2
Adj Y home magnet
down 0.100". Reset
Sensor Status.
Adj Y home magnet
up 0.60".Reset
Sensor Status.