Vendo VUE 30 - Setting the Y Stops

GFV Cabinet, set Y home adjustment.
WORK CONTENTS : Set the Y Stops.
Note: .
STEPS: (1) With all the adjustments made it is time to tap and insert the Y Stop set screws.
(2) Raise the X-Rail assembly to access the Y Stops, tap the set screw holes for
both Y stop brackets.
(3) Insert the screw set (screw and 2 washers) in both Y Stops as shown in
Step 3 and 4. Do not run the screw into the door liner.
(4) Lower the X Rail assembly to the stops, connect the Y Motor connector.
(5) Reset the power by unplugging then plugging in the power supply,
shut the door and latch it. Machine should run Discovery 2.
(6) Proceed to vending test or next test in sequence.
Step 4
Carriage
assembly.
Y Rail stop,
hinge side
adjust
set
View of Y-
Rail
stop, latch
Step 2
tap the hole.
Screw p/n
V801489, self
insert screw with
2 washers. Screw
p/n V802212,
washers p/n
V801455.
Step 3