Vendo VUE 30 - Page 137

GFV Cabinet, set Y home adjustment.
WORK CONTENTS : Checking position of the Y
-home magnet with no spacer.
Note:
.
STEPS: (1) Raise the X
-Rail and remove both spacers as shown.
(2) Lower the X
-Rail where it is resting on the Y-Rail stops.
(3) Reset the "Sensor Status" and verify the magnet is actived,
sensor status('Yo", o not filled in).
(4) If the Y Home sensor is activated ('Yo", o not filled in) go to page 9.
(4) If the Y Home sensor is inactive "Y?" ("o" filled in) adjust
(5) the Y Home magnet up 0.060 inches. Reset sensor status.
Repeat step 5 until the Y Home Sensor shows active
"Yo" ("o" not filled in), then goto page 6.
Step 1
No spacers
for this test.
View of Y
-
Rail
No spacers
for this test.
View of Y-
Rail
stop, hinge