Vendo VUE 30 - Page 136

GFV Cabinet, set Y home adjustment.
WORK CONTENTS : Checking position of the Y
-home magnet with 0.075 inch spacer.
Note: .
STEPS: (1) Raise the X
-Rail and install the 0.075 inch spacers "same as
nickle" on top of both Y Stops as shown. One on top of each stop.
(2) Lower the X
-Rail where it is resting on the Y-Rail stops and spacer.
(3) Reset the "Sensor Status" and verify the magnet is actived,
sensor status ('Yo", o not filled in).
(4) If the Y Home sensor is activated ('Yo", o not filled in) go to page 8.
(4) If the Y Home sensor is inactive "Y?" ("o" filled in)
(5) adjust the Y Home magnet up 0.060 inches. Reset sensor status.
Repeat step 5 until the Y Home Sensor shows
active "Yo" ("o" not filled in), then goto page 6.
Adjust Y
Magnet up
Y magnet
Y sensor
Step 5
Step 1
Latch side, Y-
Rail s
top bkt.
hinge side, Y-
Rail stop bkt.