Vendo VUE 30 - Page 135

GFV Cabinet, set Y home adjustment.
WORK CONTENTS : Checking position of the Y
-home magnet with 0.250 inch spacer.
Note: .
STEPS: (1) Raise the X
-Rail and install the 0.250 inch " Standard 1/4 inch
bolt" spacers on top of both Y Stops as shown. One on top of each stop.
(2) Lower the X
-Rail where it is resting on the Y-Rail stops and spacer.
(3) Reset the "Sensor Status" and verify the magnet is not
(4) activating the sensor ('Y?", o filled in).
(5) If the Y Home sensor is not activated ('Y?", o filled in)
(6) go to page 7.
(5) If the Y Home sensor is active "Yo" ("o" not filled in)
(6) adjust the Y Home magnet down 0.100 inches. Reset sensor status.
Re
peat step 5 until the Y Home Sensor
shows Inactive "Y
?" ("o" filled in), then goto page 7.
Step 1
Latch
side, Y
-
hinge
side, Y
-
Adjust Y Magnet
down 0.100
Y magnet
Y sensor
Step 5