Venmar C180 - Halogen Light Bulbs; Reinstall Bottomp; Anel

CAUTION
Remove protective plastic film covering filters before reinstalling them (if need be).
8. REINSTALL BOTTOM PANEL
Reinstall the bottom panel, using 5 screws for a single blower hood and 6 screws for a double blower
hood, as shown below.
SINGLE BLOWER HOOD DOUBLE BLOWER HOOD
Then, reinstall filters.
HO0059
HO0066
- 9 -
9. HALOGEN LIGHT BULBS
This range hood requires 120 V, 50 W, MR16 or PAR16 with GU10 base, shielded halogen lamps
(included in Connaisseur models only).
WARNING
!
Do not touch lamps during or soon after operation. Burns may occur. In order to
prevent the risk of personal injury, only install shielded halogen lamps. Also,
never install a cool beam, a dichroic lamp, a lamp not suitable for use in
recessed luminaires or identified for use in enclosed fixtures.
1. Install lamps by placing the bulb leads into
their grooves in the socket.
2. Gently push upwards and turn clockwise until
secure.
To remove lamps, gently push upwards and turn
counterclockwise to disengage bulb leads from
their grooves.
NOTE: If need be, use a rubber dishwashing
glove to add grip when removing the
bulb.
12
HO0090