Turning on and off TV
Turn on the TV
Connect the Power cable. At this time the TV will enter stand by mode.
press the button on remote control to turn on TV from standby mode.
Turn off the TV
press the button on remote control to enter standby mode.
Do not leave your set in standby mode for long periods of time. It is best to unplug the set from the
mains and aerial.
No signal
There is No Signal menu on screen when there is no input signal. In TV/DTV mode, if there is no
signal in fifteen minutes, the TV will turn off automatically. In PC mode, the TV set will automatically
turn off in five minutes if no input signal. When VGA cable is connected the TV turns on automatically.
Using the CH+/CH- on the panel of TV or on the remote control.
Program Selection
Press CH+ to increase channel number.
Using 0-9 digital buttons.
You can select the channel number by pressing 0 to 9.(In TV, DTV mode)
Press CH- to decrease channel number.
Using -/-- buttons.
Using -/-- buttons enables you to enter double digit channel numbers.
Press the VOL+/- button to adjust the volume.
Volume adjustment
If you want to switch the sound OFF, press the .
You can release mute by pressing the or increase/ decrease the volume.
You can select the input source by pressing the INPUT button on the remote control.
Changing the Input Source
Press the / button to cycle through the input source, and press the OK button to confirm your
choice.
To Next Page
Loading...
