Cable Installation
Please read the relevant content in “Notice for Maintenance and Safety” carefully before the installation and
use.
1. Take out the TV frome the package and put it in a drafty and flat place.
NOTE
When you plug or unplug the TV, computer or other equipments, you must make sure that the AC power
has been already shut down; when unplugging the power cable or signal cable, please hold the plug(the
insulated part)., do not draw the body of the cable.
2. The RF output terminal can be connected with the RF input port of the TV.
3. The output AV terminal of DVD can be connected with the AV input port of the TV through AV cable.
4. Connect one end of the VGA cable with the VGA port on computer, connect the other end of the VGA
cable with the VGA port on the TV, and tighten the bolts clockwise on the each end of VGA cable.
NOTE
While connecting the 15-pin VGA, please do not insert the plug overexertedly, for fear the pin
might be broken.
5. Connect one end of the HDMI cable with HDMI output port, connect the other end of the HDMI cable
with the HDMI port on the TV.
NOTE
While connecting the HDMI, please insert carefully, do not insert overexertedly, for fear the pin
might be broken.
6. Check and make sure that all AV cables are connected with the corresponding ports correctly.
7. Connect the AV power cable with 100-240VAC power supply.
NOTE
The range of power input for the TV is 100-240VAC 50/60HZ, do not connect the TV power input
port with the AV power out of the above range.
Please hold the insulated part of the plug when you are unplugging the power cable, do not touch
directly the metallic part of the cable.
QUICK START GUIDE
Connect
1. Connect the mains and antenna.
2. Press the button on remote control to turn on TV from standby mode.
Initial Setup
When the TV is initially powered on, a sequence of on-screen prompts will assist in configuring
basic settings.
1. Select the desired OSD(On Screen Display) language.
Press the / / / button, then press the OK button.
2. Select the appropriate country.
Press the / / / button to select the country, then press the OK button to Start
Channel Tuning.
To Next Page
Loading...
