24
0900-5165 REV-00
Using the Device
Prior to using the device, complete the instructions in the chapter Setting Up.
Procedure 1. Prepare the System
Please read the Warnings & Cautions section before performing the following tasks.
1. Ensure that each GlideScope system component has been properly cleaned or disinfected according to
the guidance provided in the Reprocessing chapter on page 28.
2. Based on a clinical assessment of the patient and the experience and judgment of the clinician, select
the GlideScope video laryngoscope that is appropriate for the patient.
3. Attach the video laryngoscope to the monitor per Attach the Blade or Baton on page 23.
Procedure 2. Perform an Intubation
Please read the Warnings & Cautions section before performing the following tasks.
To perform an intubation, Verathon recommends using the GlideScope 4-Step Technique as outlined in
this procedure. Each step begins with where the user should be looking to complete that action. Prior to
beginning this procedure, verify that the monitor is receiving an accurate image from the video laryngoscope.
During the procedure, when using a laryngoscope that is compatible, Dynamic Light Control can be
turned on or o to assist with optimizing the image quality and brightness at the vocal cords. See Set
Dynamic Light Control (Optional) on page 25 for information on using this feature.
1. Look in the Mouth: Insert the blade midline, advancing the tip until it is past the posterior aspect of
the tongue.
2. Look at the Screen: Identify the epiglottis and advance the blade into the vallecula for a view of the
glottis.
3. Look in the Mouth: Using a GlideRite stylet (optional), introduce the ET tube along the right side the
blade.
4. Look at the Screen: Complete the intubation, gently rotating or angling the tube as needed to
redirect it.
5. Remove the GlideRite stylet (optional): Pull the stylet out towards the patient’s feet
To Next Page
Loading...
