Verathon GlideScope Go - Disconnect the Blade or Baton; Remove the Stat (Video Batons Only)

26
0900-5165 REV-00
Procedure 5. Disconnect the Blade or Baton
1. To disconnect the scope from the monitor, hold the monitor in one hand and the scope’s body in the
other, and then pull. The scope disconnects from the monitor.
Procedure 6. Remove the Stat (Video Batons Only)
The GVL Stat is a sterile, single-use device. After each use, it is a biohazard, and it should be removed from
the video baton and disposed of in a manner consistent with local protocols.
1. Hold the Stat in one hand.
2. To reduce the force required to remove the video baton from the Stat, use your thumb and nger to
gently press the collar of the Stat.
3. With the other hand, grasp the handle of the video baton and pull rmly.