Verathon GlideScope Go - Maintenance & Safety; Periodic Inspections; GlideScope Go 2 Battery; System Software

29
Operations & Maintenance Manual: Maintenance & Safety
0900-5165 REV-00
Maintenance & Safety
Periodic Inspections
No periodic inspections, maintenance, or calibrations are required by Verathon.
Report any suspected defects to Verathon Customer Care or your local representative. For contact
information, visit verathon.com/service-and-support.
If the system becomes unresponsive, hold the power button for approximately 7 seconds to reset the
monitor.
GlideScope Go 2 Battery
After 300 charge and discharge cycles, the battery capacity is approximately 80% of the initial capacity.
Under normal operating conditions, this may happen at around 3 years. For more information about the
battery, see Monitor Specications on page 32.
The battery is not user-replaceable. Do not attempt to replace the battery. Any attempts to replace the
battery by unauthorized service technicians may cause serious harm to the user and will void the warranty.
For more information, contact Verathon Customer Care or your local representative.
System Software
This manual documents the most current version of the software. If your monitor does not function as
described in this manual, or to determine if your software should be updated, contact Verathon Customer
Care. Do not perform any software upgrades from third-party vendors or attempt to modify the existing
software. Doing so may damage the monitor and void the warranty.
Device Repair
The system components are not user-serviceable. Verathon does not make available any type of circuit
diagrams, component parts lists, descriptions, or other information that would be required for repairing the
device and related accessories. All service must be performed by a qualied technician. If you have any
questions, contact Verathon Customer Care or your local Verathon representative.
Please read the Warnings & Cautions section.
Device Disposal
The system and related accessories may contain batteries and other environmentally hazardous materials.
When the instrument has reached the end of its useful service life, it must be disposed of in accordance with
WEEE requirements. Coordinate disposal through your Verathon Service Center, or alternatively, follow your
local protocols for hazardous waste disposal.