4.7. Care & Maintenance
Daily Routine
Recommended cleaning procedure for Vortex Air using Azo
TM
Detergent Wipes or detergent and
water.
▪ With the lid open, clean the inside surface of the lid seal and underside of the top cover using
IPA based wipes or detergents with warm water. Please dispose of wipes and cloths once
finished (not in the macerator unless macerator friendly).
▪ Close the lid and then clean and dry the front panel of the Vortex Air.
▪ Keeping the lid closed, continue to wipe the top surface with warm water and detergent then
dry with a dry wipe.
▪ Wipe over the control panels with a damp (not wet) cloth and dry. NB. Drying each surface after
cleaning is vitally important to help prevent microbial growth.
▪ Finally start the Vortex Air to run one cycle without any disposable single-use products to flush
the hopper through and clean the inside of the macerator.
To Next Page
Loading...
