Vertex Standard FT-950 - Meter Peak Hold and Rotator Settings

FT-950
Operating Manual
Vertex Standard Co., Ltd.
111
Available Values: OFF/0.5/1.0/2.0 sec
Default Setting: OFF
008 DISP PKH PO
Function: Selects the peak hold time of the PO meter.
Available Values: OFF/0.5/1.0/2.0 sec
Default Setting: OFF
009 DISP PKH ALC
Function: Selects the peak hold time of the ALC meter.
Available Values: OFF/0.5/1.0/2.0 sec
Default Setting: OFF
010 DISP PKH ID
Function: Selects the peak hold time of the ID meter.
Available Values: OFF/0.5/1.0/2.0 sec
Default Setting: OFF
011 DISP RTR STU
Function: Selects the starting point of your rotator controller’s indicator needle.
Available Values: 0/90/180/270°
Default Setting: 0°
Advice: If the optional DMU-2000 Data Management Unit is not connected, this
adjustment has no effect.
012 DISP RTR ADJ
Function: Adjusts the indicator needle precisely to the starting point set in menu item
“011 DISP RTR STU.”
Available Values: –30 ~ 0
Default Setting: 0
Advice: If the optional DMU-2000 Data Management Unit is not connected, this
adjustment has no effect.
013 DISP QMB MKR
Function: Enables/Disables the QMB Marker (White arrow “
V”) to display on the
Spectrum Band Scope when the optional DMU-2000 Data Management Unit is